Hard Disk Drive

ASUS P4V88 DRIVER DOWNLOAD

Any ideas or advice at all would be welcome. I don’t recall what the largest partition size is when EnableBigLba is enabled in the windows registry. Firmware, you may need, but it’s difficult to find. If so, where do I get a driver that will work? The Motherboard BIOS makes no mention of SATA drives except in the section on booting and then it is just a general switch to either have the SATA boot bios enabled or disabled – it is currently enabled and I will try things with it disabled as well so that I have covered all the angles. Latest VIA chipset drivers are here: This was not so and although the drive did spin up, it was not recognised by the Windows software as a viable drive.

Uploader: Tygokasa
Date Added: 26 September 2016
File Size: 55.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 23846
Price: Free* [*Free Regsitration Required]

By the way you didn’t answer my question adus witch is the maximum hard disk capacity with this mother board. I’m going to try a reversion to an earlier bios that actually involved the SATA software.

Didn’t try any other RAM. Every time I try to install the ATI drivers is states that it cannot complete the installation and to try installing standard vga graphics first.

I understand that the VIA RAID software will actually handle single or non-raid configurations once the drives have been recognised but still no luck on this front and without the drives being seen by my system, I’m unable to partition or do anything sensible with the drives. I did note that I only have the rightmost two jumpers on my drive, one of these is the one shown above and now jumpered.

  ASUS G2SG SATA DRIVER

Did you test with 4G RAM? Do witch is the maximum capacity of hard disk supported by P4V88 motherboard? We receive spam notifications and will take immediate action!

P4V88 and SATA HDDs

Firmware, you may need, but it’s difficult to find. I don’t recall what the largest partition size is when EnableBigLba is enabled in the windows registry. This behaved just like the Samsung drives usually behave – driver quits and nothing happens. At the moment, I have both Samsung ;4v88 installed and everything else returned to its normal state with the drives non-functional.

I logged a support call with ASRock but they haven’t been able to resolve either. Please report all spam threads, posts and suspicious members. If so, where do I get a driver that will work? p4g88

ASRock P4V88, Socket 478, Intel Motherboard

Have I got a concept problem? Appropriate cables were obtained and I fitted one drive and made the required connections, ran the VIA SATA Raid driver install program and expected that all would be well. You will want to use GPT software to pv88 those 2 large hard drives.

After I had tried this a couple of times with variations including trying the other drive, I shut down the system and disconnected the drive before restarting.

I also exchanged the motherboard for a similar one which I intended to use to build a printer server, and fitted all the ancilliary hardware and started that up with identical results to those previously obtained. The Motherboard BIOS makes no mention of SATA drives except in the section on booting and then it is just a general switch to either have the SATA boot bios enabled or disabled – it is currently enabled and I will try things with it disabled as well so that I have covered all the angles.

  DSC38U VISTA DRIVER

Thanks for the jumper info which I have now tried but it didn’t seem to make any difference.

I need a brainwave or a brain! Hi again, Finally I bougth 1G, and installed. One odd thing is that if I reinstall the Raid driver without the drive connected all goes well and the Device Manager reports a successful installation!

Following some further aeus I have managed to discover that it appears to be an issue with the amount of installed RAM that causes the problem. Please report all spam threads, posts and suspicious members. We receive spam notifications and will take immediate action!

It is currently running with Windows 7 but you will need to be aware that the VIA drivers are only supported up to XP. Copyright c Tweak Town Pty Ltd.

ASRock > P4V88+

Interested to know how you get on if you go for the upgrade. I will post the results. Copyright c Tweak Town Pty Ltd. Code 10 ‘ followed by an invitation to start the troubleshooter which I did.