Table shows the DS Storage System interoperability matrix of multipathing drivers. This entry was posted on October 11, , But he surprised of what he has seen from my configuration: By pressing ‘print’ button you will print only current page. Turned off pSwitch2 and the connection were alive too to the SAN Storage and the number of paths changed from four to two. Disk Security with Full Disk
|Date Added:||17 July 2006|
|File Size:||10.11 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
DS logical drive representation in Windows Server The main reason I need a redundant networking is failover not load balancing.
Page – Chapter 8. You are commenting using your WordPress.
But when i look at the properties of the multipath disk drive, i found “MPIO” tab is missing in the properties. Post was not sent – check your email addresses!
IBM Subsystem Device Driver Device Specific Module (SDDDSM) – United States
In my windows i found most of the info provided on and around page are similar. To print the manual completely, please, download it. Read the information from readme file for firmware Page – Chapter Table shows the DS Storage System interoperability matrix of multipathing drivers.
There you need to check only the Utilities part. Thank you again for any hints.
Ds350 is the accepted answer. Email required Address never made public. Did i miss any configuration that needed? Page – Dual Controller DS with two or more Administration – Subsystem Ma Leave a Reply Cancel reply Enter your comment here Table DS Storage System interoperability matrix of multipathing drivers.
I have two Windows Host connected to it. Looking for Multipathing software to be installed on my windows Host to manage load balance multipath.
After that the ping is steady without DUP! You can leave a responseor trackback from your own site.
IBM DS3500 Introduction And Implementation Manual: Microsoft Windows Mpio
You can follow any responses to this entry through the RSS 2. Hi, i would need to setup a similar configuration two esx 4. First of all mpioo for the good info. Turned off pSwitch2 and the connection were alive too to the SAN Storage and the number of paths changed from four to two.
By pressing ‘print’ button you will print only current page. Unanswered question This question has not been answered yet. To find out more, including how to control cookies, see here: Page Page – Sample command: By continuing to use this website, you agree to their use. Answered question This question has been answered. Got it, continue to dz3500.