Hard Disk Drive

GP300 PROGRAMMING DRIVER DOWNLOAD

How to covvert M for HAM needs. Motorola Radius GP Programming. See a video of the software in use If you want a copy of Motorola Doctor software just join the following group Click to join RadioDoctor You will also need a simple interface to connect the radio to your PC. Press F8 and program any target GP Motorola Radius GP programming software two way radio. MDF and can be found in the main directory of the Motorola software.

Uploader: Felmaran
Date Added: 22 November 2004
File Size: 16.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 17325
Price: Free* [*Free Regsitration Required]

You should probably find an entry at addresses 06D0h, replace with FE1Eh.

Motorola Radius GP300 Programming Software

If hp300 compare the new checksum with the original one for the file they probably will bp300 different. Out of Band Information, Prgoramming Method. By RadEng posted November 24th7: RSS for MT, ver Tuner for Professional Radios R Also, an older pc works best especially like a P1 or P2. This is the hex representation for the number of channels in the radio, in this case 16ch. If you have Windows 7 then this site provides links to the ISO and help on how to use it.

You do this with the help of a Hex editor such as Hex Workshop This can be found and downloaded on http: I have made a small video that shows the Hex Workshop screen during the modification.

  C905 CAMERA DRIVER DOWNLOAD

Once the checksum’s of the files match you should be able to run the RSS, load the codeplug, and enter the frequencies within your new bandsplits with ease. Service manual for new M radio non-full. Change the 3 low pass filter coils near the antenna from 7 turns to 3 turns and the 4 capacitors to 12pF.

GP/P/GP/GP/GP88

General Information The model breakdown table for the GP series of radios and a general guide for lots of others: The channel switch is the same regardless of which radio you have. If you have one of the GP 5-tone models with a display, it shows an error something likeand it doesn’t want to accept a codeplug, you can try turning on the radio with all the side buttons pressed including PTT.

By hamed posted October 17th2: Click to type your reply to 5P1CC’s message, pfogramming was: Tuner for professional radios R There is a lot on Youtube explaining how to reprogram the Motorola GP but very hard to find which software to use.

Edit this to be “70”.

You want to edit the byte right after the end of the serial number. Tweak them down all the way inside the coils, and they will lock on Note the model number that the codeplug has programmiing as, and compare it to the original model number of the radio.

  DVC USBS DRIVER

Point leader-board This leader-board shows the top 5 point holders as of this week updated weekly. If it was hijacked on your proggamming then it is likely that your anti-virus software removed it.

Motorola GP (Product) RSS Programming Software – HamFiles

By changing the series resistor to 1K ohm instead of ohm the problem was overcome. Search Downloads Search Use inverted comas to refine your search. If this doesn’t work, then try the method below. vp300

Avi-file Look and study! The latest on the receiver is I have it down to.

Some of the codeplug structure, disabling the encryption, cloning, etc. If the 2 channels programmed in the radio come up in the order 1,2,2,2,2, Load the file back in your hex editor and make a Checksum of the file. You will also need to jumper around or modify the VCO low pass filter on the receive side.